Differences

This shows you the differences between two versions of the page.

--- ruijie:switch:general_configuration_switch_l2 [2020/09/22 20:29] – aperez
+++ ruijie:switch:general_configuration_switch_l2 [2020/09/22 20:39] – aperez
@@ Line 1737: / Line 1737: @@
 !
 ----
-**interface TenGigabitEthernet 0/50
+**interface TenGigabitEthernet 0/50**
- storm-control broadcast pps 3000
+**storm-control broadcast pps 3000**
- description CONEXION SWITCH CORE  IP:  10.1.0.1
+**description CONEXION SWITCH CORE  IP:  10.1.0.1**
- switchport mode trunk
+**switchport mode trunk**
- ip dhcp snooping trust**
+**ip dhcp snooping trust**
 ----
@@ Line 1762: / Line 1761: @@
 ** no shutdown**
 !
@@ Line 1889: / Line 1887: @@
 **Ruijie#copy running-config startup-config**
-------------------------------------------
+----
-Ruijie>enable
-Ruijie#configure termina
-Ruijie(config)#interface gigabitEthernet 0/1
-Ruijie(config-if-GigabitEthernet 0/1)#storm-control broadcast level 1    ------>storm-control limits the number of broadcast packets to 1% of the bandwidth that is 1G*1%=10M
-Ruijie(config-if-GigabitEthernet 0/1)#storm-control unicast level 1         ------>storm-control limites the number of unknown unicast packets to 1% of the bandwidth that is 1G*1% =10M
-Ruijie(config-if-GigabitEthernet 0/1)#storm-control multicast level 1
-To configure storm control on a port with keyword pps, perform this task:
-Ruijie>enable
-Ruijie#configure termina
-Ruijie(config)#interface gigabitEthernet 0/1
-Ruijie(config-if-GigabitEthernet 0/1)#storm-control broadcast pps 200    ------>storm-control limits the number of broadcast packets to 200 packets per seconds
-Ruijie(config-if-GigabitEthernet 0/1)#storm-control unicast pps 200      ------>storm-control limits the number of unknown unicast packets to 200 packets per seconds
-Ruijie(config-if-GigabitEthernet 0/1)#storm-control multicast 200
-Ruijie(config-if-GigabitEthernet 0/1)#end
-------------------------------------------
-Si tenemos problemas de conectiviad, con un solo cable conectado y es una instalacion nueva aplicar las siguientes lineas:
 Ruijie(config)#no spanning-tree mode
-Ruijie(config)#no spanning-tree vlan 1,3-5,7,9-11     (todas las vlans que apliquen)
+Ruijie(config)#no spanning-tree vlan 1,3-5,7,9-11     (all VLANs)
 ------------------------------------------