Differences

This shows you the differences between two versions of the page.

--- aruba_networks:switch:2930f:configuration:configure_lacp_on_aruba_2930f_jl259a_connect_hp_a5500hi [2025/08/27 15:27] – aperez
+++ aruba_networks:switch:2930f:configuration:configure_lacp_on_aruba_2930f_jl259a_connect_hp_a5500hi [2025/08/27 15:32] (current) – aperez
@@ Line 911: / Line 911: @@
 ===== PoE Configuration and Behavior in Aruba =====
-The switch is operating at its best effort under the ''802.3af'' PoE standard (~11 W).
+The switch is operating at its best effort under the **802.3af** PoE standard (~11 W).
-The AP-515 Access Point requires ''PoE+ (802.3at)'' to operate both radios, as its consumption is ~18–22 W.
+The AP-515 Access Point requires **PoE+ (802.3at)** to operate both radios, as its consumption is ~18–22 W.
-When the switch only delivers ~10–11 W, the AP-515 enters ''IPM'' (Intelligent Power Management) mode and shuts down the 2.4 GHz radio. In this situation, the right LED on the AP-515 blinks amber.
-<note>
-The default switch configuration only provides 15 W, which is insufficient for the AP-515. The solution is to force the delivery of a higher power value.
-</note>
+> **Note:** The default switch configuration only provides 15 W, which is insufficient for the AP-515. The solution is to force the delivery of a higher power value.
 ==== Configuration Procedure ====
 <code bash>
-Aruba-Stack-2930F(config)# int 1/41        # ⟵ PUERTO 1/41
+Aruba-Stack-2930F(config)# int 1/41     # <-- PUERTO 1/41
 Aruba-Stack-2930F(eth-1/41)# poe-lldp-detect enable
 Aruba-Stack-2930F(eth-1/41)# poe-allocate-by value
+Aruba-Stack-2930F(eth-1/41)# poe-value 30  # <-- APLICAR 30 W EN EL PUERTO 1/41
 </code>
-<note warning>
+> **Warning:** Using ''poe-allocate-by value'' may result in undesired PoE behavior. Prefer ''class'' or ''usage'' when possible.
-Using the ''poe-allocate-by value'' command is considered a risk. The switch warns that it may result in undesired PoE behavior and recommends using ''class'' or ''usage''.
-</note>
-<code bash>
-Aruba-Stack-2930F(eth-1/41)# poe-value 30  # ⟵ APLICAR 30 W EN EL PUERTO 1/41
-</code>
 ==== Verifying PoE Status ====
@@ Line 948: / Line 937: @@
 | 1/42 | Yes | low | off | usage | usage | 0.0 W | 0.0 W | Searching | 0 | - |
 | 1/43 | Yes | low | off | usage | lldp  | 11.0 W | 10.0 W | Delivering | 4 | 2 |
 ----
 ----
  --- //[[gm@itclatam.com|Antonio Perez]] 2024/07/23 22:16//