Differences

This shows you the differences between two versions of the page.

--- ruijie:switch:system_management:telnet_management [2020/09/24 23:36] – hvillanueva
+++ ruijie:switch:system_management:telnet_management [2020/09/25 00:13] (current) – hvillanueva
@@ Line 1: / Line 1: @@
-**TELNET MANAGEMENT**
+====== TELNET MANAGEMENT ======
 Telnet is an application protocol used on the Internet or local area network to provide a bidirectional interactive text-oriented communication facility using a virtual terminal connection.
@@ Line 5: / Line 5: @@
 Next, a small scenario is carried out where a serial cable is connected from the PC to the Ruijie Switch and assign an IP address for the management of the Switch by Telnet.
-  * **Network Topology**
+=====1. Network Topology=====
 This will be the topology for this scenario:
@@ Line 11: / Line 12: @@
 {{:ruijie:switch:system_management:ruijie_telnet_1.png?400|}}
-  * **Configuration Steps**
+=====   2. Configuration Steps =====
+- Console connect to device
+- Set ip and gateway
+//ruijie(config)#interface vlan 1//
+//ruijie(config-if-VLAN 1)#ip address 192.168.1.1 255.255.255.0//
+//ruijie(config)#ip route 0.0.0.0 0.0.0.0 192.168.1.2//
+- Set telnet password
+//ruijie(config)#line vty 0 4//
+//ruijie(config-line)#password ruijie//
+- Set enable password
+//Ruijie(config)#enable password ruijie//
+===== 3. Verification =====
+- Telnet 192.168.1.1
+{{:ruijie:switch:system_management:ruijie_telnet_2.jpg?600|}}
+- Input telnet password
+{{:ruijie:switch:system_management:ruijie_telnet_3.jpg?400|}}
+- Input enable password
+{{:ruijie:switch:system_management:ruijie_telnet_4.png?400|}}