Antonio Perez

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
======LAN TO LAN VIA BRI ISDN MODULE======


**1.** Adding a Lan user to Lan.


  add user LAN-ETECEN password chicago type network,dial_out
  disable user LAN-ETECEN
  set user LAN-ETECEN idle_timeout 300
  
  
**2.** Configuring the user network parameters.

  set network user LAN-ETECEN address_selection specified remote_ip_address 78.0.0.2/A
  set network user LAN-ETECEN ipx disable appletalk disable bridging disable
  set network user LAN-ETECEN send_password chicago default_route_option enable mtu 1514 spoofing enable
  
  
**3.** Setting User Dial-Out Parameters

  set dial_out user LAN-ETECEN local_ip_address 78.0.0.1/A    
  set dial_out user LAN-ETECEN site type ondemand
  
  
**4.** Configuring user routing parameters

  set network user LAN-ETECEN ip_routing both rip ripv2
  
  
**5.** Setting the PPP parameter

  set network user LAN-ETECEN PPP compression_algorithm stac max_channels 2 channel_expansion 60 channel_decrement 20
  
**6.** Setting the phone number


  set user LAN-ETECEN phone_number 0,012162008
  
**7** Configurando la Autentificación


  set ppp receive_authentication 
  set system transmit_authentication_name LAN-ETECEN


**8.** Saving the parameters.


  Enable user LAN-ETECEN
  Save all
  
  


---------------------------



 --- //[[nce@itclatam.com|David Gonzalez]] 2021/04/16 16:19//