======RECOVERY PASSWORD======



Press the **reset** button when the leads are on, press the letter "**H**" from the tera term then with the command "**L**" , it will list the version and the existing address. Lastly with the command "**F**": write the name of the file to load valid for the 3000 switch: F LS3K3_23.SLX


**Commands for Device Configuration**:-

    L                  list the current settings of these parameters.
    A ip-address       set the IP address of the device.
    D ip-address       set the IP address of the default gateway.
    M subnet-mask      set the IP subnet mask.
    R                  reset the Management Software's configuration of
                       the serial port to default values when it is next
                       restarted
    G                  "Go": restart the device without performing an upgrade.
**
Commands for Software Upgrade**:-

    F filename         specify the name of the software image file.
    S ip-address       set the IP address of the TFTP file server
    S ipx-address      set the IPX address of the TFTP file server
    B                  start the software upgrade.
    B ip-address       start the upgrade, from the specified file server
    B ipx-address      start the upgrade, from the specified file server
    
    
    
    

  --- //[[nce@itclatam.com|David Gonzalez]] 2021/04/15 10:16//