**COPYING LOG TO SERVER**

**I. Requirements**

Copy logs with severity from 0 to 7 to syslog server.

**II. Network Topology**

{{:ruijie:switch:image011.png?400|}}

**III. Configuration Tips**

Timestamps and sequence number features must be enabled before system copys logs to log server

**IV. Configuration Steps**

Ruijie>enable

Ruijie#configure terminal

Ruijie(config)#service sequence-numbers          ------>enable sequence number

Ruijie(config)#service timestamps                ------>enable timestamps

Ruijie(config)#interface vlan 1

Ruijie(config-if-VLAN 1)#ip address 192.168.1.1 255.255.255.0

Ruijie(config-if-VLAN 1)#exit

Ruijie(config)#logging server 192.168.1.2        ------>specify log server IP address

Ruijie(config)#logging source ip 192.168.1.1     ------>specify IP address on switch to communicate with log server

Ruijie(config)#logging trap 7                    ------>copy all logs(severity from  0 to 7) to log server

Ruijie(config)#end

Ruijie#wr

**V. Verification**

This example shows how to verify the logs in a syslog server using "Kiwisyslog"

{{:ruijie:switch:image012.jpg?400|}}