Table of Contents

INSTALLATION RELEASE 3.3.1 FOR ACCESS POINTS

Before doing any procedure, the following items should be verified:

Requirements:

Procedure

If the AP has a Release less than or equal to 2.7.

1. Connect the AP directly to the PC that has the Software Releases.

2. Make sure that the AP and the PC are in the same network segment. To do this, it is verified through the WIDMAN which IP address the AP has:

3. Now the “3Com Enterprise AP Upgrade Kit” must be executed and in its fields enter the IP address of the Access Point, the Username which is admin and the Password would be blank.

4. Click Upgrade. Then a “Command” is displayed where the correct operation of the Upgrade process can be verified.

5. Once the Upgrade process is finished, the software will display a message of completed action, at which the option “Exit” will be selected.

6. Now the version of Release that was installed must be verified on the AP. For this we must enter the configuration of the AP and in Advanced Settings select “Administration”.

7. At this moment the AP Version must be 3.2.0. Now a TFTP server must be running, in this case “3CSERVER” is running.

8. Now in the “Administration” page of the AP, in the file name fields, write the name of the Release, in the IP Address field, enter the address where the TFTP server is located, in the Username field write “admin” and finally in the Password field do not type anything.

9. Clic on Upgrade.

10. Once the installation of the Release is finished, the “Reboot” option will appear in the Window, you must click here.

11. At this time the AP already has the new image version.

Note: If the AP that you want to update has a software version greater than or equal to 3.1.0. Steps 6-11 should be followed only.

For more information visit:

http://www.3com.com/products/en_US/result.jsp?selected=6&sort=effdt&order=desc&sku=3CRWE875075A

David Gonzalez 2021/04/06 11:01