RECOVERY PASSWORD

Press the reset button when the leads are on, press the letter “H” from the tera term then with the command “L” , it will list the version and the existing address. Lastly with the command “F”: write the name of the file to load valid for the 3000 switch: F LS3K3_23.SLX

Commands for Device Configuration:-

L                  list the current settings of these parameters.
A ip-address       set the IP address of the device.
D ip-address       set the IP address of the default gateway.
M subnet-mask      set the IP subnet mask.
R                  reset the Management Software's configuration of
                   the serial port to default values when it is next
                   restarted
G                  "Go": restart the device without performing an upgrade.

Commands for Software Upgrade:-

F filename         specify the name of the software image file.
S ip-address       set the IP address of the TFTP file server
S ipx-address      set the IPX address of the TFTP file server
B                  start the software upgrade.
B ip-address       start the upgrade, from the specified file server
B ipx-address      start the upgrade, from the specified file server

– David Gonzalez 2021/04/15 10:16