Press the reset button when the leads are on, press the letter “h” from the tera term then with the command “l” , it will list the version and the existing address. Lastly with the command “F”: write the name of the file to load valid for the 3000 switch: F LS3K3_23.SLX

Commands for Device Configuration:-

  L                  list the current settings of these parameters.
  A ip-address       set the IP address of the device.
  D ip-address       set the IP address of the default gateway.
  M subnet-mask      set the IP subnet mask.
  R                  reset the Management Software's configuration of
                     the serial port to default values when it is next
                     restarted
  G                  "Go": restart the device without performing an upgrade.

Commands for Software Upgrade:-

  F filename         specify the name of the software image file.
  S ip-address       set the IP address of the TFTP file server
  S ipx-address      set the IPX address of the TFTP file server
  B                  start the software upgrade.
  B ip-address       start the upgrade, from the specified file server
  B ipx-address      start the upgrade, from the specified file server
  
  
  
  

1. – David Gonzalez 2021/04/15 10:16