ITC/3AV WIKI

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

**FACTORY RESET IAP's**

**Option 1:**

You can reset using the command below, I believe it needs to be completed on a per AP basis

**write {erase <all> <reboot>}**

**Option 2:**

{{:snip20180813_9.png?600|}}

**Option 3:**

Execute reset factory default process:

{{:ap_315.png?600|}}

{{:iap_375.png?600|}}

{{:iap_375-1.jpg?600|}}

--The reset button can be used to return the access point to factory default settings. To reset the access point, refer to the steps below:

1. Power off the access point.

2. Press and hold the reset button using a small, narrow object, such as a paperclip

**3. Power-on the access point without releasing the reset button. The power LED will flash within 5 seconds**

4. Release the reset button.


**Note:  You should turn it off, hold a paperclip in the reset button, put power to it for 10 seconds and then release. It should take about 3 to 5 minutes for the instant SSID to show up and the a/b/g lights should turn green.**


The power LED will flash again within 15 seconds indicating that the reset is completed. The access point will now continue to boot with the factory default settings