aruba_networks:switch:4800:irf_configuration:error_the_device_is_not_in_the_current_irf
This is an old revision of the document!
Problem Description : Error: The device is not in the current IRF
- Product Model # : 4800G
- Software / Firmware version : 5.20 2202
- Fact : Attempting to add an IRF device to a stack, that was previously configured or misconfigured.
1.- Resetting the device back to factory defaults does not remove the IRF number
ERROR: The device is not in the current IRF.
Unable to add a new device to an IRF Stack
Cause : If a device has been previously configured with an incorrect member ID or does not match the stack member ID, the new device will not synchronize with the existing stack.
Fix : Use the following command to determine the current Member ID
4800G]dis irf conf MemberID NewID IRF-Port1 IRF-Port2 *4 4 1 2
* indicates the device is the master.
+ indicates the device through which the user logs in.
Undo irf member 4 renumber Undo irf member 4 irf-port 1 Undo irf member 4 irf-port 2
4800G]dis irf conf MemberID NewID IRF-Port1 IRF-Port2 *4 1 disable disable
* indicates the device is the master.
+ indicates the device through which the user logs in.
Save Reboot
Then issue the commands
Irf member 1 renumber 3 Irf member 1 irf-port 1 port 1 Irf member 1 irf-port 2 port 2 Save Reboot
Connect the new unit to the IRF Stack.
aruba_networks/switch/4800/irf_configuration/error_the_device_is_not_in_the_current_irf.1614647151.txt.gz ยท Last modified: 2021/03/01 20:05 by dgonzalez