ITC/3AV WIKI

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== TELNET MANAGEMENT ======

Telnet is an application protocol used on the Internet or local area network to provide a bidirectional interactive text-oriented communication facility using a virtual terminal connection.

Next, a small scenario is carried out where a serial cable is connected from the PC to the Ruijie Switch and assign an IP address for the management of the Switch by Telnet.

=====1. Network Topology=====


This will be the topology for this scenario:

{{:ruijie:switch:system_management:ruijie_telnet_1.png?400|}}

=====   2. Configuration Steps =====


- Console connect to device

- Set ip and gateway

//ruijie(config)#interface vlan 1//

//ruijie(config-if-VLAN 1)#ip address 192.168.1.1 255.255.255.0//

//ruijie(config)#ip route 0.0.0.0 0.0.0.0 192.168.1.2//

- Set telnet password

//ruijie(config)#line vty 0 4//

//ruijie(config-line)#password ruijie//

- Set enable password

//Ruijie(config)#enable password ruijie//

===== 3. Verification =====

- Telnet 192.168.1.1

{{:ruijie:switch:system_management:ruijie_telnet_2.jpg?600|}}

- Input telnet password

{{:ruijie:switch:system_management:ruijie_telnet_3.jpg?400|}}

- Input enable password

{{:ruijie:switch:system_management:ruijie_telnet_4.png?400|}}