ITC/3AV WIKI

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Creating And Adding External Mount Disk On SonicWall Analytics ======

**DESCRIPTION:**

This documents helps to Create and Add External mount disk for SonicWall Analytics

**RESOLUTION:** 

**1.-** Login to ESXi Console and select the Analytics VM and right click select Edit Settings

{{:sonicwall:hard_disk:090190425286546.jpeg?nolink&200|}}
  NOTE: It is recommended to allocate disk capacity as per license. Also make sure that free disk space is available in VM datastore.
  
**1.-** Now power on Analytics VM in vSphere and below message will show up on Console screen. Initial boot-up may take 5 to 10 minutes.

{{:sonicwall:hard_disk:090190425458833.jpeg?nolink&200|}}

**1.-** After bootup following screen will show up, double-click on the orange-brown Management Console screen.

{{:sonicwall:hard_disk:090190425276941.jpeg?nolink&200|}}

In Management Console, use keyboard arrow keys and select Storage in the Menu and press Enter

{{:sonicwall:hard_disk:090190425610029.jpeg?nolink&200|}}

Now in main Storage screen use arrow key to select Add Storage, select Yes and press Enter to Confirm

{{:sonicwall:hard_disk:090190425191510.jpeg?nolink&200|}}

Now insert 4 digit number for key (for encryption) and note it down for later use. press Enter to Confirm

{{:sonicwall:hard_disk:090190425233472.jpeg?nolink&200|}}

  NOTE: The Encryption key will help secure storage and needed to re-configure storage.

**1.-** Once Confirmed, disk encryption will start as shown below and ‘Mount storage’ option will appear

{{:sonicwall:hard_disk:090190425691413.jpeg?nolink&200|}}

**1.-** Click Enter and provide the encryption key (recorded earlier) and now you  will get below pop-up

{{:sonicwall:hard_disk:090190425551789.jpeg?nolink&200|}}

1.- Select Yes and press Enter again to Confirm and machine will Reboot.

2.- After reboot, again open Management Console and navigate to the Network Interface in the Menu and press Enter and select ens160.

3.- By default DHCP is enabled so it will automatically get the Network Interface config and show up as below.

4.- If DHCP is not available or want to use Static IP, use arrow keys to Disable DHCP and provide Network config i.e. IP address, Netmask, Gateway, DNS.

5.- Take note of the IP address to access On-Premises Analytics instance.

{{:sonicwall:hard_disk:090190425810015.jpeg?nolink&200|}}