aruba_networks:ap:the_aruba_125_access_point_show_me_il_flags
The Aruba 125 access point show me il flags
- Make sure the VLAN the access point is on has dhcp
- Make sure the controller has an ip interface on that VLAN
- Make sure control plane security is turned off:
- (configuration> network> controller> control plane security> Disabled> Apply.
By CLI set: ADP enable
adp discovery {disable|enable} igmp-join {disable|enable} igmp-vlan <vlan>
(Aruba7030) [mynode] (config) #ADP discovery enable
aruba_networks/ap/the_aruba_125_access_point_show_me_il_flags.txt · Last modified: 2020/11/26 16:46 by hvillanueva