Table of Contents
SHOW COMMANDS
show all-timezones
Use the show all-timezones command to view all available time zones.
Syntax
show all-timezones
Example
The following displays an example of the show all-timezones command output:
show date
Use the show date command to view the system date, time, and time zone information.
Syntax
show date
Example
The following displays an example of the show date command output:
show dns
Use the show dns command to view DNS (Domain Name System) servers.
Syntax
show dns
Example
The following example of show dns command output displays the DNS servers configured for the current Policy Manager server:
show domain
Use the show domain command to view the Active Directory Domain controller information.
Syntax
show domain
Example
The following displays an example of the show domain command output:
show fipsmode
Use the show fipsmode command to find whether FIPS (Federal Information Processing Standard) mode is enabled or disabled.
Example
The following example shows that FIPS mode is enabled:
show hostname
Use the show hostname command to view the hostname of the current Policy Manager server.
Syntax
show hostname
Example
The following displays an example of the show hostname command:
show ip
Use the show ip command to view the IPv4, IPv6, and DNS information of the host.
Syntax
show ip
Example
The following example of the show ip command displays the IPv4, IPv6, and DNS information of the host:
show license
Use the show license command to view the Policy Manager license information.
Syntax
show license
Example
The following displays an example of the show license command output:
show ntp
Use the show ntp command to view the IP addresses of the primary and secondary Network Time Protocol (NTP) servers configured for the current Policy Manager server.
The show ntp command also displays information such as the NTP authentication key details corresponding to the NTP server configured (for example, Key ID and hash algorithm).
Syntax
show ntp
Example
The following displays an example of the show ntp command output:
show ports
The show ports command shows the status of all the ports, including any filtering on incoming or outgoing traffic on the particular port. If you use the configure port command to filter inbound or outbout traffic on a selected port, the accept or reject rule assigned to the port will be reflected in the output of this command.
Syntax
show ports
Example
The following displays an example of part of the show ports command output:
show sysinfo
Use the show sysinfo command to view the node uptime, disk utilization, and memory utilization information:
Syntax
show sysinfo
Example
The following displays an example of the show sysinfo command output:
show timezone
Use the show timezone command to view the current system time zone.
Syntax
show timezone
Example
The following displays an example of the show timezone command output:
show version
Use the show version command to view the Policy Manager software version and the hardware model.
Syntax
show version
Example
The following displays an example of the show version command output:
— Humberto Villanueva 2020/12/01 14:59