CLI Reference Guide for ArubaOS-CX, ArubaOS-Switch, and Cisco IOS
Introduction: Aruba designed this CLI Reference Guide to help Hewlett Packard Enterprise partners and customers who:
- Manage multi-vendor networks that include HPE/Aruba and Cisco core and aggregation switches
- Have experience deploying Cisco switches and are now deploying HPE/Aruba switches
This CLI Reference Guide compares many of the common commands in three switch operating systems:
- ArubaOS-CX, ArubaOS-switch and Cisco IOS.
In this guide, we refer to 8400 as ArubaOS-CX, HPE ProVision as ArubaOS-Switch, and Cisco IOS is referenced as Cisco.
The ArubaOS-CX operating system runs on the 8400, 8320 and 8325 switches. The ArubaOS-switch operating system runs on Aruba 2530, Aruba 2920, Aruba 2930F, Aruba 2930M, Aruba 3810M, Aruba 5400R, HPE 2620, HPE 3500, HPE 5400 and HPE 3800 switch platforms.
The commands included in this guide were tested on the following:
- Aruba 8400 – 8 slot chassis with dual management modules running ArubaOS-CX 10.01.0001
- Aruba 3810M-24G-PoE+ switch running ArubaOS-Switch KB.16.03.0003
- Cisco switch running Cisco IOS Software 15.0(1)SE
Additional Aruba and Cisco switches and/or routers were used to provide systems connectivity and operational support as necessary. Likewise, various computers and Voice over IP (VoIP) phones were used to help test functionality and provide output for commands such as show or display.
cli_reference_guide_for_arubaos-cx_arubaos-switch_and_cisco_ios-c04793912.pdf
cli_reference_guide_for_arubaos-cx_arubaos-switch_comware_and_cisco_ios.pdf
0-notices-hpe_aruba_and_cisco_cli_ref_guide.pdf